Veined Round Vessel Sink with Tap Hole
The veined round vessel sink with tap hole places a small tap seat at the rear of a circular ceramic bowl. The complete top plan shows a round boundary around that rear hole, while the factory photograph shows a tap standing on the corresponding integrated seat. Branching brown lines cross the cream inside and outside. A reflective circular waste position appears in the bowl floor. The original side drawing has shallow straight sloping walls above a broad lower line. Both outside horizontal spans are 440 mm, and the full outside height is 120 mm. Coordinate the rear tap seat and circular body together without treating the pictured tap as a confirmed supplied accessory.
Shape & size
Shape and size of SHY-8004D1
Small rear tap seat
A round seat boundary sits within the circular outline
The complete top plan shows a tap hole inside a small round boundary near the rear rim. The factory photograph places a tap on that integrated area. This seat stays within the circular outside outline rather than forming a long separate side platform.
Branching brown lines on cream
The visible treatment crosses inside and outside
The original photograph shows brown branching lines over a cream body, continuing across the inner walls and exterior. These are visible appearance facts on a ceramic basin. They do not establish a stone body or a stone material specification.
Shallow straight sloping side walls
The full outside profile is 120 mm high
The complete side drawing shows straight sloping walls meeting a broad lower line. Its 120 mm mark describes the full outside height. This shallow outside profile does not publish an independent internal bowl depth or a separate support width.
Circular 440 mm outside outline
The matching spans measure one round body
The complete top drawing keeps a circular outside outline with a 440 mm span. The side drawing repeats that outside width. The equal measurements do not indicate a square body or separate internal diameter.